configure eaps multicast temporary-flooding

Description

Configures the switch to temporarily enable multicast flooding when an EAPS topology change occurs.

Syntax Description

Default

Off.

Usage Guidelines

When this feature is set to on and an EAPS topology change occurs, the switch temporarily enables multicast flooding to all protected VLANs for the duration specified by the following command:

If you change the configuration to off, topology changes that occur after this command do not result in temporary flooding. For example, if you change the configuration to off while flooding is in progress for a protected VLAN or set of protected VLANs (due to an EAPS topology change), the flooding continues for the configured duration period. New topology changes on the protected VLANs do not cause flooding.

When this feature is set to off and an EAPS topology change occurs, the switch does not enable flooding to all protected VLANS during the topology transition. The default switch response for multicast traffic during an EAPS topology change is that defined by the following command:

You can also use the following command to configure the switch response for multicast traffic during an EAPS topology change:

History

This command was first available in ExtremeXOS 12.1.2.

Platform Availability

This command is available on all Universal switches supported in this document.